Flow control in Gas Chromatography

Reliable, sensitive, and selective high-resolution measurements using compact measuring instruments are among the expectations of a Gas Chromatography user. Being aware of these requirements, Bronkhorst has developed compact (MEMS based) flow solutions to meet the needs of gas chromatography manufacturers.

The Bronkhorst flow controllers have a compact design, offering stable gas flow control, good reproducibility and simple integration in your process. These flow controllers are a good fit for Gas Chromatography users.

Check out our recommended products

Flow solution for gas chromatography

Gas chromatography is a widely used analytical technique which allows the qualitative and quantitative characterization of a sample. Such sample is injected through a sample injector in a stream of carrier gas. The gas stream is controlled using a very accurate mass flow controller (IQ⁺ FLOW series). The sample to analyse will go through the stationary heated column where its components elute at different times. Analytes are then detected by a specific type of detector. Each component of the sample will generate a different peak, enabling sample’s constituents identification. The attained peaks also permit a quantitative analysis through the calculation of the peaks areas.

Chemical plants frequently use these analysers to check process parameters in real time, thereby requiring faster run times. Such a requirement is hard to achieve, because it is difficult to reach a good balance between faster cycles while keeping acceptable levels of separation.

MEMS-based gas flow controller

Analysis becomes much faster if a higher flow rate is used, but by doing so the separation between analytes will be less efficient, therefore increasing flow rates may compromise the analyser’s sensitivity.

Our IQ+FLOW series, are MEMS-based flow controllers and very compact in design. And therefore an ideal fit for gas chromatography users