H₂ Flow Control in natural Power to Gas

In Germany a group of companies are developing technologies to have bacteria excrete methane based on hydrogen and carbon dioxide as their ‘food’. This can be considered as a natural power-to-gas application for storing green electricity and a treatment technology for process gases containing carbon dioxide (CO₂) as well. The methane (CH₄) is to be fed into the natural gas network which is already present. These companies requested Bronkhorst’s distributor, Wagner Mess- und Regeltechnik, to supply mass flow controllers to provide the bacteria with enough hydrogen and CO₂ as well.

Check out the Bronkhorst solution

‘Power to gas’ refers to the conversion of electricity to gas. A well-known example is using electricity for the electrolysis of water to generate hydrogen, with oxygen as a by-product. If the hydrogen subsequently reacts with carbon dioxide to methane, the latter can be introduced to the natural gas network. In countries like Germany and the Netherlands, there is an existing infrastructure to transport natural gas trough pipes from the place where it is extracted or processed to the place where it is used – for central heating in houses or for the stove in the kitchen. 

 

 

Process solution

The Bronkhorst H₂ flow control solution to supply hydrogen to the reaction vessel is an IN-FLOW gas mass flow controller with a typical flow rate ranging from 10 to 50 ln/min hydrogen. The reactor vessel is operated under anaerobic conditions at a temperature of 65 °C and pressures between 1 and 10 bars. Most type of bacteria feel most comfortable at atmospheric pressure, others at a higher pressure. The bacteria metabolise hydrogen and carbon dioxide and convert them into methane. The lab in which the experiments are conducted is classified as a hazardous area ATEX zone 2, therefore, the flow controllers need an ATEX zone 2 approval.  

The gas mass flow controller is controlled via Profibus. A setpoint is given, and the actual value is measured and recorded. Data are logged so that the test values are documented. Experiments typically run for 48 hours and automation is important here. When an error occurs, such as a serious deviation between the setpoint and the actual value, actions have to be taken - even overnight. The advantage of electrically controlled mass flow controllers is that the hydrogen supply can be stopped easily in case of a failure or emergency, without human interference.