Bronkhorst

PROFIBUS DP Interface

Bronkhorst® Mass Flow Meters/Controllers can be directly used as PROFIBUS DP slaves. By using the SPC3-Asic of Siemens Baud rates of up to 12 MBaud can be achieved.

afbeelding
EL-FLOW Select Mass Flow Controller (MFC) with Profibus-DP Interface
EL-FLOW Select Mass Flow Controller (MFC) with Profibus-DP Interface

Characteristics

  • Baud rates from 9,6 kBaud up to 12 MBaud
  • +15 Vdc or +24 Vdc supply voltage
  • modular slave with max. 50 data modules
  • flexibility of data-configuration by selecting suitable modules
  • parameter-data setting by means of a configuration tool is supported
  • max. 244 Bytes input and max. 244 Bytes output
  • freeze and synchronization is supported
  • connection to PROFIBUS DP by means of Sub-D-9 connector
  • PROFIBUS DP slaves, using SPC3-chip, automatically adapt to baudrates determined by the master
  • station-address setting by microswitch on instrument
  • tooling software or PROFIBUS DP Master configuration software
  • galvanic isolation up to 500 V (for data lines)
  • connection of max. 124 instruments 1 bus
  • maximum bus length 1200 metres at 9,6 kBaud, 100 metres at 12 MBaud


PROFIBUS system example
afbeelding

Certificate

The PROFIBUS Nutzerorganisation e.V. granted Bronkhorst High-Tech B.V. certificates for their PROFIBUS Slaves MBC2 and MBC3.

PROFIBUS DP downloads

PROFIBUS Accessories
PROFIBUS DP GSD
PROFIBUS GATEWAY GSD
PROFIBUS DP manual

ブロンコスト・ジャパン株式会社
〒135-0016
東京都江東区東陽5-27-5

Tel.  03-3645-1371

sales◎bronkhorst.jp   ◎を@に置き換えて下さい

     
Copyright © 2024 Bronkhorst. All rights reserved.     サイトマップ     免責事項     プライバシーポリシー