Bronkhorst

IN-LINE Filter

Ultra Low Flow Serie M-420

  • Filters for Mass Flow Meters / Controllers
  • For increasing the MTBF (Mean Time Between Failure)
  • Contains a 316L sintered metal filter cartridge
  • Housing: AISI 316
  • O-rings: Viton; optional EPDM and FFKM (Kalrez)
Get a quote Downloads Support
IN-LINE Filter<br /><H2>Ultra Low Flow Serie M-420</H2>

Description

Inherent to its construction, a thermal mass flow meter or controller for gases is sensitive to contamination. To increase the MTBF (Mean Time Between Failure) it is important to make sure that the gas entering the instrument is clean. The IN-LINE Filter Assembly, screwed into the inlet of the instrument, provides this service. It contains a 316L sintered metal filter cartridge that is suitable for general purpose filtration and can be cleaned with a suitable solvent. If the gas contains a large particulate content, we advise the use of a pre-filter.

 

Selection

This Ultra Low Flow filter has a ⅛” female thread at the inlet and a ⅛” male tread on the outlet.The M-420 series has a porosity (µm) of 0.5, 2, 7 or 15 μm, depending on the model. The pressure rating for this model is 200 bar. The ΔP across the IN-LINE filter can be calculated with the help of our online calculation tool FLUIDAT on the Net.

Technical specifications

Available models
Model no. Average porosity (µm) Connections in Connections out Pressure rating
M-420-13 0.5 1/8" female 1/8" male 200 bar
M-420-16 2 1/8" female 1/8" male 200 bar
M-420-18 7 1/8" female 1/8" male 200 bar
M-420-20 15 1/8" female 1/8" male 200 bar

Dimensional drawings

Downloads

Brochures
Filters brochure
Dimensional drawings
Dimensional Drawing M-410 / M-420
For dimensional drawings and hook-up diagrams please visit the product page on our website



BRONKHORST (UK) Ltd

1 Kings Court
Willie Snaith Road
Newmarket Suffolk CB8 7TG
Tel. +44 1223 833222
[email protected]

         Social Responsibility
Copyright © 2024 Bronkhorst. All rights reserved.     Sitemap     Disclaimer     Privacy note